30622-01A - Page 3
Turn bench over. Install hinge brackets
to ends of bench such that the short
boss engages the stud above the bolt
hole, and the long boss engages the
hole below the bolt hole. Secure using
5/16” x 1” Allen-head bolts and 5/16”
metal washers. Tighten bolt snug, then
an additional half turn.
7
STUD
SHORT BOLT
Lift the canopy and hold it
between the hinge brackets.
9
Place the bushings
into hinge brackets.
8
Insert 5/16” x 1 1/2” bolts with nylon
washers into both hinge brackets. Tighten
bolts into the endcap threaded inserts
until snug, then an additional half turn.
Do not overtighten to avoid damaging
threaded inserts.
10
The gas springs have a locking
mechanism. Follow the directions
below for the type you received.
11
With a helper holding the canopy
open, align ends of gas spring ball
joints with pivot studs and push
into place. Be sure rod end is down
as shown. DO NOT lower canopy
until both gas springs are engaged!
12
Lift and lower canopy a few
times to lubricate gas springs
for optimum performance.
13
Plug the three-prong 220V AC
power cord into a dedicated outlet
(see
Electrical Requirements
).
15
Type 1
Pry back the
locking clip
with a
fl
at
screwdriver.
Type 2
Remove locking
clip to install or
remove gas spring.
PIVOT STUD
CAUTION
Failure to engage locking clips may
result in the ball joints working loose,
allowing the canopy to fall, which may
result in damage to the unit and injury.
THREADED
LOCKING RING
RECEPTACLE
ON BENCH
CANOPY TO BENCH
POWER CORD
REMOTE PORTS
WIRED
REMOTE
PORTS (RJ-22)
WIRELESS
REMOTE
PORT (RJ-11)
Connect the canopy to
bench power cord to the
bench receptacle. Align the
terminals and
fi
rmly push
on until seated then tighten
the threaded locking ring.
14
The unit is shipped with
a Remote Control Bypass
Plug installed. Your sunbed
will not operate without
either the bypass plug or a
remote system connected. If
remote operation is desired,
see
Remote Connections
.
16
