ASSEMBLY INSTRUCTIONS
CL150N Single Glider
Tools Not Included but Required:
7/16” wrench, either a power tool, hand driver or ratchet wrench that will accept a 1/4” hex drive bit
Tools Included:
#2 Square Drive Bit, 4mm Driver Bit
Back
Step 1
1. First you will assemble the base. Unfold the two assembled leg
sections and connect to each other with the two connecting braces
and the four 3" lag screws.
Parts Included:
1 - Seat
1 - Back
2 - Arms (Left & Right)
2 - Assembled Leg Sets
2- Connecting Braces
1- Bag of Hardware
Step 2
Stainless Steel
Hardware Included:
8 - 3 1 /2" bolts
4 - 2 3/4" bolts
2 - 2
1
/2" bolts
4 - 3" lag screws
2 - 2" deck screws
14 - fl anged lock nuts
Seat
Assembled Leg Sets
Arms
Connecting
Braces
Bag of
Hardware
2. Attach the seat using the eight 3-1/2" bolts. Start by placing
the seat in position on top of the assembled lower frame. The
front of the seat is the straight edge and the front of the lower
frame is the side with the straight legs. Once in position, align
the holes from the legs with the holes in the seat supports and
place a 3-1/2" bolt through from the outside to inside. It is
easiest if you start with a front leg on one side and then move to
the front leg on the other side and then do the back legs in the
same manner. Once you have a bolt in all the eight holes, place
a fl anged lock nut on each bolt. ONLY HAND TIGHTEN for now.
