10
DISPLAY:
Shows the set temperature in °F or °C and the Auto-
timer settings. While on FAN only mode, it shows the
room temperature.
TEMP/TIMER
ERROR CODES:
AS - Room Temperature Sensor Error
- Unplug the
unit and plug it back in. If error repeats, call
Consumer Services at 844-472-2473.
HS - Electric Heating Sensor Error
- Unplug the
unit and plug it back in. If error repeats, call
Consumer Services at 844-472-2473.
● -
Evaporator Temperature Sensor Error
- Unplug
the unit and plug it back in. If error repeats, call
Consumer Services at 844-472-2473.
NOTE:
If an error code occurs in Fan only mode, the
unit will display “LO” (loose connection) or “HI”
(short circuit).
NOTE:
If the unit breaks off unexpectedly due to power being
cut, it will automatically restart with the previous
function setting when the power resumes.
AIR DIRECTIONAL LOUVERS:
Use the 4-way directional louvers to direct the air flow
up or down and left or right throughout the room as
needed. Pivot horizontal louvers until the desired up/
down direction is obtained.
Move the levers from side to side until the desired
Left/Right direction is obtained.
ADDITIONAL THINGS YOU
SHOULD KNOW:
● The Cool circuit has an automatic 3 minute time-
delayed start if the unit is turned off and on quickly.
After unit is turned off, leave unit off for a minimum
of 3 minutes before attempting to turn back on.
This prevents overheating of the compressor
and possible circuit breaker tripping. The fan will
continue to run during this time.
● The control is capable of displaying temperature in
degrees Fahrenheit or degrees Celsius. To convert
from one to the other, press and hold the Up and
Down Temp/Timer buttons at the same time for
3 seconds.
FRESH AIR VENT CONTROL
(on some models):
The Fresh Air Vent allows the air conditioner to:
1. Recirculate inside air (Vent Closed - Fig. A)
2. Draw fresh air into the room (Vent Open - Fig B)
3. Exchange air from the room and draw fresh air into
the room (Vent and Exhaust Open - Fig C)
Air Direction
Levers
Display
Evaporator Temperature Sensor Error
Fig. A
(VENT CLOSED)
Fig. B
(VENT OPEN)
Fig. C
(VENT AND EXHAUST OPEN)
