Installation and Operation Manual for the
PERENIO IONIC
SHIELD™
Cold Plasma Emitter
© Perenio IoT spol s r.o. All rights reserved
Document version: 1.0.8
Page
25
of
35
4.
Connect the Device to a power source using the original power adapter. The
power button LED will turn green, yellow, or red depending on the battery level
(See Table 1 “LED Indicator Statuses”).
NOTE
. The original power adapter (
output: 5V/2A
) included in the delivery
package shall be used to connect the Device to the mains, or a compatible
portable charger (See the
“
Warnings
and Restrictions”
Section).
5.
Wait for the battery to be recharged (It takes no more than three (3) hours).
NOTE
. When the battery is fully recharged, the power button LED will turn green
(
See Table 1 “LED Indicator Statuses”
).
6.
Disconnect the Device from the power source (The LED will go off) and put it
on a flat horizontal surface, or mount on a vertical surface using screws (not
included in the delivery package) in an closed room or a vehicle.
NOTE
. If the LED blinks after disconnecting the device from the power source, it
means the Device is on, and ion emission was stared.
2.2 Operation Process
ATTENTION!
Before operation, make sure you carefully read the
“
Warnings and
Restrictions”
Section of this document, and that the capsule is inserted into the
Device and tightened properly.
1.
To start the ion emission process, press the power button once (The LED indicator
will start blinking according to Table 1 “LED Indicator Statuses”).
ATTENTION!
Do not touch the capsule while the Device is operating!
2.
To stop the ion emission process, press the power button once again (The LED
indicator will be on or off according to Table 1 “LED Indicator Statuses”).
The average operating time of the Device depends on the size of the enclosed area
of application (See Table 2 above).
NOTE.
Continuous operation of the Device is allowed.
Содержание IONIC SHIELD PEWOW01COV
Страница 2: ......
