background image

Operating instructions

To turn the receiver ON or OFF press and hold the push-button for 2 sec.
It will start either in frequency mode or in channel mode. Frequency mode will display a frequency and
channel mode will display a channel number (two digit number from 01 to 40) and the corresponding
frequency. The receiver will start in the same mode that it was in when it was previously turned off.
In case of low voltage “LOW BAT” is seen on display. If the FREQ knob on the front is pushed the display is
illuminated for 6 seconds or as long as the knob is moved. The knob must be pressed down and released
to be able to change the frequency.

To toggle between modes, press and hold the FREQ knob until the mode changes. This can be seen on the
LCD.

Frequency Mode

Changing the frequency:

To change the frequency from the one displayed begin by pressing, then releasing the

FREQ knob

. The

rightmost digit will be underlined. Change that digit by rotating the knob. To move to the next digit to the
left, press and release the knob again. Continue changing the frequency using the method described.

Channel Mode

Setting the channel frequency:

1. Utilise the frequency mode to tune the receiver to the desired frequency according to the method

described above.

2. Press and hold the FREQ knob until the text “Channel xx” is displayed. XX represents a two-digit number

ranging from 01 to 40.

3. Turn the FREQ knob until the desired channel is displayed. If too much time elapses between pushing

the dial and rotating the dial you must begin again. The indication that too much time elapsed is that the
line under the channel number will disappear.

4. To set the new frequency of the channels quickly press and release the On/Off button. This must be

done before the background light goes off. Note that the receiver will turn off if the button is
press and held.

VHF Receiver

Instructions

View Product

Please

Recycle

PERDIX Wildlife Supplies. Unit 1 Hatton Rock Business Park,

Hatton Rock, Stratford-Upon-Avon, CV37 0BX. UK

Tel: +44 (0)1789 336123 www.perdixwildlifesupplies.com

Visit our site

Содержание RX-98

Страница 1: ...s micro processor controlled It covers any 2 MHz band between 138 and 175 MHz An adjacent 2 MHz band can be included as an option The receiver includes 40 programmable channels and it also includes a scanner function for the programmed channels The PERDIX VHF receiver has one external antenna socket The frequency is set by a knob to the closest 1 kHz Also fine trimming of the frequency tone and th...

Страница 2: ...igit by rotating the knob To move to the next digit to the left press and release the knob again Continue changing the frequency using the method described Channel Mode Setting the channel frequency 1 Utilise the frequency mode to tune the receiver to the desired frequency according to the method described above 2 Press and hold the FREQ knob until the text Channel xx is displayed XX represents a ...

Страница 3: ... Point preferably horizontally with the front of the external directional antenna at the transmitter To set the transmitter frequency press the FREQ knob and release it to change the 1 kHz digit underlined by turning the FREQ knob Push the FREQ knob again to change the 10kHz digit underlined and set the frequency by turning the knob In the same way the 100 kHz and the MHz can be changed When the l...

Страница 4: ...iver has good dynamic properties which makes it easy to use even close to a strong transmitter Care As mentioned above do not keep the batteries in the receiver during prolonged periods of non use If the receiver has been used in heavy rain and there is moisture inside open the battery compartment take out the batteries and let the receiver remain open over night in a dry and warm place This norma...

Отзывы: