PERCo TTR-10A Series, Руководство по сборке и эксплуатации

Страница: 7 / 34

Assembly & Operation Manual
4.2 Optional equipment supplied on request
Turnstile power supply ...................................................................................................................... 1
WRC kit
1
.......................................................................................................................................... 1
Intrusion detector ............................................................................................................................. 1
Siren.................................................................................................................................................. 1
5 BRIEF DESCRIPTION
5.1 Main features

The turnstile is designed to work both indoors and outdoors or inside vehicles. The turnstile
housing is made of high quality stainless steel with polycarbonate insert.

The turnstile can operate independently or with control devices: the RC-panel, WRC or ACS.

The turnstile is equipped with automatic anti-panic folding arms. The barrier arm is set into
vertical position at a power loss or by emergency unblocking device Fire Alarm signal.

The turnstile is equipped with an operating mode indication. The turnstile provides an output
for connecting an additional external display as well.

The turnstile is equipped with relay inputs for an intrusion detector, a siren and the
emergency unblocking Fire Alarm device (i.e. fire protection system) connection.

The turnstile is equipped with an output for a power supply low voltage alarm connection.

There are two modes for the turnstile control - a pulse control mode and a potential control
mode.

The turnstile mechanism provides automatic barrier arm rotation to the initial position after
each pass.

After the barrier arms are turned 60° or more, the reverse rotation is blocked.

The rotor electric drive provides smooth and silent operation of the turnstile.

The turnstile is supplied with safe 24V voltage.
5.2 Design
The design of the turnstile (Fig. 2). Numbers in brackets correspond to Fig. 2 and 3 of this Manual.
The turnstile comprises turnstile base (6), housing (1) LED indication unit (2), hub (4) with three
barrier arms (3) and RC-panel. Additionally, depending on modification, the turnstile is equipped
with a mounting bracket for cylindrical racks (for example, in vehicles), for wall mounting, or
mounting post for installation on the floor. Optional equipment that is not included in the main
delivery set is supplied on request.
Figure 2. Turnstile components without a mounting bracket (post)
1 – turnstile housing; 2 – LED indication unit; 3 – barrier arm; 4 – hub;
5 – hub mounting screws; 6 – turnstile base; 7 – housing mounting screws
1
The WRC kit consists of a receiver connected to the control board and transmitters.
6