PERCo TTR-10A Series, Руководство по сборке и эксплуатации

Страница: 19 / 34

Assembly & Operation Manual
Modification
TTR-10AT
,
TTR-10AK , 1 box in each:
Transportation box dimensions (L×H×W) ................................................................... 104×40×32cm
Transportation box weight (gross) ..................................................................................... max 58kg
Modification
TTR-10AB , 2 boxes:
Transportation box #1 dimensions (L×H×W) .............................................................. 104×40×32cm
Transportation box #1 weight (gross) ................................................................................ max 53kg
Transportation box #2 dimensions (L×H×W) .............................................................. 115×40×22cm
Transportation box #2 weight (gross) ................................................................................ max 33kg
7 SAFETY REQUIREMENTS
7.1 Installation safety requirements
The turnstile installation must be carried out by specialists who have fully studied this manual and
passed safety training, in accordance with the general rules for the implementation of electrical and
installation work.
Warning!

The power source or battery must be turned off and unplugged during installation of the
turnstile.

Only serviceable tools must be used for installation.

Lay the cables in compliance with the electrical installations rules of operation.

Before turning on the turnstile for the first time, make sure it's installed and connected
correctly.
Power supply unit installation must be made in accordance with the safety rules given in its
certificate.
7.2 Operation safety requirements
Follow general electrical safety rules when operating the turnstile.
It is prohibited!

Do not use the turnstile under conditions that do not comply with the requirements of
Section 2 of this Manual.

Do not use the turnstile at supply voltage that does not comply with the requirements of
Section 3 of the Manual.
The power supply unit should be used in compliance with its operational documentation.
8 INSTALLATION INSTRUCTIONS
Follow the safety requirements during the installation (Sect. 7.1).
Warning!
The manufacturer is not responsible for any damage to the turnstile or other equipment, as
well as other damages caused by improper installation, and rejects any consumer
complaints if the installation is performed in violation of the instructions given in this
manual.
8.1 Installation details
The turnstile installation is a demanding operation, both performance and service life of the product
largely depend on it. Installation must be carried out by at least two specialists qualified as an
installer and an electrician. It is recommended to study this section carefully prior to installation,
and follow the given instructions.
Installation surface recommendations:
The turnstile can be mounted on the cylindrical racks (vertical pipes) of the vehicle using the
MT10.1 bracket (for TTR-10AT modification), or on a strong vertical wall with the MT10.2 bracket
(for TTR-10AK modification), or on a concrete floor using the MT10.3 mounting post (for
TTR-10AB modification).
18