perco.com linkedin.com/mwlite/company/perco [email protected] +7 (812) 247-04-64
A13
Walkway downlights power supply (+12 V / 3 A)
Walkway downlights
LED
Indication blocks of passage directions A and B
RA, RB
ACS readers
1, 2
Indication cables
3
Passage zones power cables
4
External cable for powering walkway downlights
5
Jumpers for switching "IMP/POT" mode
6
Fire Alarm jumpers are connected if there is no Fire Alarm device (A7)
DIN-rail description
Contact
Electrical circuit
Designation
1, 2
+24 V, GND
Power supply connection
3-5
+12 V, Detector, GND Intrusion detector connection
6, 7
Fire Alarm, GND
Emergency unlocking input
8
RC Sound
RC-panel sound indication output
9-11
UnlockA, Stop,
UnlockB
Turnstile control inputs
12-14
RS LedA,
RS LedStop,
RS LedB
RC-panel indication outputs
15, 16
IMP / POT
Turnstile control mode setting
17
+12 V
Output for powering additional devices
18, 19
Alarm 1, Alarm 2
Siren connection outputs
20
Common
Common contact for PASS A, PASS B, Ready, Det Out signals
21
PASS A
PASS A relay contact (passage in the direction A)
22
PASS B
PASS B relay contact (passage in the direction B)
23
Ready
Ready relay contact
24
Det Out
Det Out relay contact
25-30
NO, Light, NC
Relay contacts for connecting remote indicators
31-36
+12 V, LED, GND
Contacts for connecting indication blocks located on the guide
barrier set
37, 38
U1, U2
Connection of the walkway downlights power supply
Operation
algorithm
Each passage zone can operate from the RC-panel (included in the delivery set), WRC or
ACS controller. Operation is performed by applying a low-level signal to unlock A, Stop and
Unlock B contacts relative to the GND contact. Response to these signals depends on the
control mode the user has selected (specified by if the IMP/POT jumper wire is installed /
removed on the DIN-rail of the passage zone).
Pulse control mode is when a pulse is applied to the Unlock A (B) input, the passage zone
rotor will automatically unlock for a single passage in the direction A (B). The waiting time for
the passage being completed does not depend on the duration of the control pulse and lasts
5 seconds. Sending a pulse to the Stop input locks the rotor in both passage directions.
Simultaneous sending of pulses to the Unlock A (B) and Stop inputs places the passage zone
in the "Free passage" mode in the selected direction.
It is recommended to use pulse mode during operation from RC-panel or WRC. The
orientation of RC-panel buttons can be changed by swapping the wires from the RC-panel
that are connected to the unlock A and Unlock B contacts, as well as Led A and Led B,
respectively.
Potential control mode is when the control signal is applied to the Unlock A (B) input, the
passage zone rotor unlocks in the selected direction during the entire holding signal time.
RTD-20 Full height rotor turnstile
