PERCo RTC-15, Руководство по сборке и эксплуатации, гарантийный талон

Страница: 14 / 22

Protective Canopy RTC-15
8.3.14.3 Install the bracket on the flanges and fix it with the earlier undone screws
(Fig. 9);
8.3.14.4 Mark the turnstile top channel for two Ø8.5 mm holes to mount the bracket
with the screws
М 8×30.
8.3.14.5 Undo the screws and take off the bracket.
8.3.14.6 Drill two Ø8.5 mm holes as marked.
8.3.14.7 Mount the bracket on the flanges, fix the bracket by two screws
М 6×40 with
nuts and washers. Do not tighten the screws.
8.3.14.8 Put two screws
М 8×30 through the holes in the bracket and fasten them by
nuts with washers from inside the top channel, as shown in Fig. 9.
8.3.14.9 Tighten all the bracket screws.
8.3.15 In the same way, mount the «Turnstile-Canopy» bracket from the side of the
turnstile guide barrier set (Fig. 8).
Fig. 8 Positioning of the «Turnstile-Canopy» brackets
between the canopy jointing flanges (6) and the turnstile top channel
8.3.16 Paste the joint line between the flange edges and the flanges/the top channel with
a clear silicon sealer.
8.3.17 Installation check-up:
8.3.17.1 Take a visual check-up whether the direction of the water drainage off the
canopy is as chosen.
8.3.17.2 Check all the threaded connections, tighten when necessary.
8.3.18 Install the cover on the turnstile top channel.
13