Pepwave MAX, Руководство пользователя

Страница: 55 / 121

http://www.pepwave.com 55 Copyright @ 2013 Pepwave
VPN Settings
Active
Check this box to enable the VPN.
Encryption
By default, VPN traffic is encrypted with 256-bit AES standard. If the option Off is selected
on both sides of a VPN connection, no encryption will be applied.
Remote ID
Pepwave MAX establishes VPN connection with a remote peer that has a serial number or
a remote ID here.
Pre-shared Key
This is an optional field which defines the pre-shared key used for this particular VPN
connection. The VPN connection's session key will be further protected by the factor of the
pre-shared key. The connection will be up only if the pre-shared keys on each side match.
When the remote peer is running firmware 5.0 or 5.1, this setting will be ignored.
Remote IP
Addresses / Host
Names
Enter the remote peer’s WAN IP address(es) or host name(s) here. Dynamic-DNS host
names are accepted.
This field is optional. With this field filled, the Pepwave MAX will initiate connection to each
of the remote IP addresses until success. If the field is empty, the Pepwave MAX will wait
for connection from the remote peer. Therefore, at least one side of the two VPN peers has
to have the field filled. Otherwise, VPN connection cannot be established.
Enter one IP address or host name per line.
Data Port
If Default is selected, VPN data will go through UDP port 4500.
Select Custom and enter a port number if a specific outgoing port is desired.