Pepperl+Fuchs OHV110-F228-R2, Руководство пользователя, Страница: 11 / 55

OHV110-F228-R2
Installation
2
0
2
0
-0
9
11
3.1.2 Establishing a USB Connection
Establishing a USB Connection
1.
Insert the USB plug on the connection cable into a free USB port on the PC. This step can be
carried out even during operation.
2.
When the handheld reader is successfully connected, an audible signal will be emitted and the
handheld reader will vibrate.
The handheld reader is now ready.
3.1.3 Establishing an RS-232 Connection
Establishing an RS-232 Connection
1.
Switch off the PC.
2.
Insert the RS-232 plug on the connection cable into the RS-232 port on the PC.
3.
Insert the low-voltage plug on the power supply unit into the low-voltage socket on the RS-232
connection cable.
4.
Connect the mains power plug on the power supply unit to the mains.
5.
Switch on the PC.
Once you have switched on the PC, the handheld reader will switch itself on automatically.
6.
If the connection is successful, the function indicator lights up green, an acoustic signal
sounds, and the handheld reader vibrates.
The handheld reader is now ready.
7.
Read the following code using the handheld reader.
Figure 3.3 RS-232 Connection
The function indicator on the handheld reader lights up green. An RS-232 connection is
established.
The handheld reader uses the following RS-232 factory settings:
• 115,200 baud
• 8 data bits
• No parity
3.2 Installing Device Drivers
The handheld reader registers itself as an input device or keyboard. Special device drivers are
not needed.
The operating system automatically installs the drivers for input devices (Human Interface
Device).