peplink PEPWAVE BR1 Classic, Руководство пользователя

Страница: 165 / 424

match. When the peer is running firmware 5.0+, this setting will be ignored.
Enter Remote IDs either by typing out each Remote ID and Pre-shared Key, or by
pasting a CSV. If you wish to paste a CSV, click the
icon next to the “Remote
ID / Preshared Key” setting.
Remote
ID/Remote
Certificate
These optional fields become available when X.509 is selected as the Pepwave
MAX’s VPN authentication method, as explained above. To authenticate VPN
connections using X.509 certificates, copy and paste certificate details into these
fields. To get more information on a listed X.509 certificate, click the
Show Details
link below the field.
Allow Shared
Remote ID
When this option is enabled, the router will allow multiple peers to run using the
same remote ID.
NAT Mode
Check this box to allow the local DHCP server to assign an IP address to the
remote peer. When
NAT Mode is enabled, all remote traffic over the VPN will be
tagged with the assigned IP address using network address translation.
Remote IP
Address / Host
Names
(Optional)
If NAT Mode is not enabled, you can enter a remote peer’s WAN IP address or
hostname(s) here. If the remote uses more than one address, enter only one of
them here. Multiple hostnames are allowed and can be separated by a space
character or carriage return. Dynamic-DNS host names are also accepted.
This field is optional. With this field filled, the Pepwave MAX will initiate connection
to each of the remote IP addresses until it succeeds in making a connection. If the
field is empty, the Pepwave MAX will wait for connection from the remote peer.
Therefore, at least one of the two VPN peers must specify this value. Otherwise,
VPN connections cannot be established.
Cost
Define path cost for this profile.
OSPF will determine the best route through the network using the assigned cost.
Default: 10
Data Port
This field is used to specify a UDP port number for transporting outgoing VPN
data. If
Default is selected, UDP port 4500 will be used. Port 32015 will be used if
the remote unit uses Firmware prior to version 5.4 or if port 4500 is unavailable. If
Custom is selected, enter an outgoing port number from 1 to 65535.
Click the icon to configure data stream using TCP protocol
[EXPERIMENTAL].In the case TCP protocol is used, the exposed TCP session
option can be authorised to work with TCP accelerated WAN link.
Bandwidth Limit
Define maximum download and upload speed to each individual peer. This
functionality requires the peer to use PepVPN version 4.0.0 or above.
WAN Smoothing
While using PepVPN, utilize multiple WAN links to reduce the impact of packet
loss and get the lowest possible latency at the expense of extra bandwidth
consumption. This is suitable for streaming applications where the average bitrate
requirement is much lower than the WAN's available bandwidth.
https://www.peplink.com 165 Copyright @ 2021 Peplink