peoplenet PD5, Руководство по установке

Страница: 15 / 18

Page | 15
Testing
Once the PMG/PCG and Display are paired, a full test is recommended. Follow the steps below to confirm function.
First, login to the device. If you do not have a Driver ID/Password, contact your system administrator for a test ID.
Once logged in, verify the following:
Go to System OBC Diagnostic Diagnostic Basic and verify:
o
GPS= 3D Indicates the GPS is currently reading. This may not show if the vehicle is indoors.
o
Cell Strength is >2 Indicates relative cell signal strength on a scale of 0-7.
Go to System OBC Diagnostic Diagnostic Device and verify:
o
Ignition reads ON when the vehicle key is on and OFF when the key is off and OFF in accessory.
With the key ON, go to System OBC Diagnostic Diagnostic PerformX and verify:
o
RPM matches engine
o
Odometer Type: ECM and Odo: matches dash
o
FUEL TYPE = ECM and FUEL: >0 gallons
Confirm the Display Power button LED is green, indicating charging
o
Disconnect the PD5 from the cable and verify the LED turns to Blue and the display remains powered up
NOTE: A fully charged battery will supply power for roughly 15 minutes, though a new unit may not have
a full charge
Any accessories (Satellite, OBDii, GPIO, PTO) activated and confirmed. See accessory guide for details.