Pentium GA - 586AL, Руководство пользователя

Страница: 46 / 50

GA-586AL
________________________________________________________________
________________________________________________________________
46
Setup shadow RAM - Enable shadow according to Setup.
F Test DMA Controller 0 BIOS checksum test.
Keyboard detect and initialization.
10 Test DMA Controller 1
11 Test DMA Page
registers Test DMA Page Registers.
12-13 Reserved
14 Test Timer Counter 2 Test 8254 Timer 0 Counter 2.
15 Test 8259-1 Mask Bits Verify 8259 Channel 1 masked interrupts by alternately turning
off and on the interrupt lines.
16 Test 8259-2 Mask Bits Verify 8259 Channel 2 masked interrupts by alternately turning
off and on the interrupt lines.
17 Test Stuck 8259's
Interrupt Bits Turn off interrupts then verify no interrupt mask register is on.
18 Test 8259 Interrupt
Functionality Force an interrupt and verify the interrupt occurred.
19 Test Stuck NMI Bits
(Parity/IO Check) Verify NMI can be cleared.
1A Display CPU clock.
1B-1E Reserved
1F Set EISA Mode If EISA non-volatile memory checksum is good, execute EISA
initialization. If not, execute ISA tests an clear EISA mode flag.
Test EISA Configuration Memory Integrity (checksum &
communication interface).
20 Enable Slot 0 Initialize slot 0 (System Board).
21-2F Enable Slots 1-15 Initialize slot 1 through 15.
30 Size Base and
Extended Memory Size base memory from 256 K to 640 K extended memory
above 1 MB.
31 Test Base and
Extended Memory Test base memory from 256 K to 640 K and extended memory
above 1 MB using various patterns.
F
This will be skipped in EISA mode and can be "skipped"
with ESC key in ISA mode.
32 Test EISA Extended
Memory If EISA Mode flag is set then test EISA memory found in slots
initialization.
F
This will be skipped in ISA mode and can be "skipped" with
ESC key in EISA mode.
33-3B Reserved
3C Setup Enabled
3D Initialize & Install
Mouse Detect if mouse is present, initialize mouse, install interrupt
vectors.
3E Setup Cache Controller Initialize cache controller.
3F Reserved
BF Chipset Initialization Program chipset registers with Setup values.
40 Display virus protest disable or enable.
41 Initialize Floppy Drive &
Controller Initialize floppy disk drive controller and any drives.
42 Initialize Hard Drive &
Controller Initialize hard drive controller and any drives.
43 Detect & Initialize
Serial/Parallel Ports Initialize any serial and parallel ports (also game port).
44 Reserved
45 Detect & Initialize Math
Coprocessor Initialize math coprocessor.
46 Reserved
47 Reserved
48-4D Reserved
4E Manufacturing POST
Loop or Display Reboot if Manufacturing POST Loop pin is set. Otherwise
display any messages (i.e., any non-fatal errors that were