76570EM 24
12. 0-S300
(1) 0-S300
(2) TY-CNL-D1.7x4.0 x2
Apply screw lock
13. [ADJ] AF Joint stroke
[Required equipment] Vernier calipers
*If AF mode SW lever (A115) is installed, set the AF mode SW lever to AF position.
(1) AF coupler (0-S300) must be projected from the mount surface by 1.2 mm or more.
(2) When the mount lock pin comes to the mount surface with depressing the mount lock lever, the
AF coupler must not be projected out of the mount surface.
(3) Adjust 0-A121 by turning an eccentric screw, and apply the screw lock agent to the screw.
14. 0-M100
[Required equipment] Hexagonal screwdriver 1.5mm
(1) 0-M100 (when replacing 0-M100 put M125 at sensor side)
(2) TY-CNL-D1.7x4.0 x3
(3) [ADJ] Temporary adjustment of AF block --- Screw in 3
adjusting screws until they stops, then screw back two turns.
[NOTE] After CCD position adjustment with programmed
software is done, Apply screw-lock agent to between the
head of adjustment screws and washers.
15. 0-J100
(1) M7--- Apply small amount of bond.
(2) M10
(3) 0-J100
(4) M5
(5) W5(t=0.25), TY-CNL-G1.7x5.0
[Note of Disassembly]
(1)
Set the diopter lever at left side then remove 0-J100.
[Note of Disassembly]
When removing 0-S300, while
pressing mount lock lever and
remove from upper side of motor.
SL
(1)
(2)
(1)
(2)
(3)
SL
(2)
(1)
(3)
(2)
