SolarTouch Controller Firmware Update User’s Guide
5
Connect Programmer to SolarTouch
®
Control Panel
1. Open the front cover of the controller. Remove the three (3) screws
securing the control panel. Flip the control panel up to access the
control panel circuit board.
Note: Be careful not to stretch the ribbon
cable connecting the control panel to the main circuit board.
2. Locate the 5-pin header programming connector JP2 on the control
panel circuit board.
Note where pin 1 is located.
SolarTouch Control Panel Circuit Board
5-pin header
programming
connector
Pin 1
Connecting the Programmer
Connect the USB cable (provided) to the programmer and to a USB
port on the PC. Note: If a USB hub is being used, the hub must be
powered with its own power supply.
PICKit
®
4 programmer
