KREEPY KRAULY
®
PROWLER
®
910 Robotic Aboveground Pool Cleaner Installation and User’s Guide
6
KREEPY KRAULY
®
PROWLER
®
910 Robotic Aboveground Pool Cleaner Installation and User’s Guide
TROUBLESHOOTING
Problem
Possible Cause
Corrective Action
Cable twisting or cable
coils up.
Obstruction in pool
Gets stuck on main drain cover
Excess cable in the pool
Remove obstruction in pool.
Turn off filter and install main drain cover ring.
Straighten cable and lay in sun periodically.
Remove excess cable from pool.
Cleaner is moving in
circles
Dirt stuck in moving parts
Tracks worn due to extended use
Power supply positioned incorrectly
Wrong mounting of bottom lid
Algae in pool.
Remove dirt from moving parts.
Contact your dealer. Replace tracks.
Place power supply in a position so that the cleaner
can reach all walls.
Lock bottom lid in the right position.
Correct pool and water conditions.
Cleaner does not reach
all areas of the pool
Power supply positioned incorrectly
Algae on pool floor
Pool filter and pump is on
Place power supply in a position so that the cleaner
can reach all walls.
Brush pool floor.
Turn off pool filter and pump and run another
cleaning cycle.
Motor not working
Impeller blocked
Drive system blocked
Electrical problem - motor unit, floating
cable, or power supply
Remove impeller tube. Clean impeller.
Clean tracks and wheels.
Consult with your dealer or service center.
Cleaner will not sink
Air caught in trapped in cleaner
Turn cleaner upside down under water to remove
trapped air. Wash the cartridge. Remove calcium
deposits or other chemical sediments.
Open inlet flap in the bottom lid to remove dirt and/or
trapped air.
Power supply or power
supply switch light is
not working
Not plugged in properly or main socket is
damaged
Reconnect and check main power supply.
