- 3 -
Press
MENU
/
Auto Setup
Use the Auto Setup feature for first-time setup of standard configurations. Follow the on-
screen prompts and enter information about your system configuration (pH/ORP internal
or external pumps, pool size, filter time, chemical container size etc). IntelliChem uses
this information to automatically setup reminder times, calculate feed times, proportional
limits and alarms. The following describes the Auto Setup screen. Press the
MENU button
to access the Auto Setup menu. To change a menu setting or value press the
/
Up/
Down arrow button
. Press the MENU button to save each selection.
Previous Values:
Use to recalculate new dose times etc., if no custom settings exist. Not
recommended for custom settings; use the menu directly to make these changes.
Reset All:
Make major configuration changes that may have conflicts with previous
settings.
IntelliChem Auto
__Setup Wizard__
Press MENU to go to
each new step
Would you
like to use
previous values?
[Yes | Reset All]
Auto Setup Sequence
Dosing will
resume when you
_exit this menu_
Press any button
To exit Auto Setup,
press
Press UP/DWN to select.
Press MENU. (Resetting
defaults and Password).
Press MENU.
What is your
Hardware Setup?
pH ORP
[RELAY2 ICHLOR]
What size is the
body of water?
Volume: 10K
Units: gal-US
Enter doser pump
rated output for
pH: 50 GPD (1-400)
How long does
your filter run?
Daily: H:08 M:00
What is the pH
Container Size?
3.5 gal-US
Gauge: 6
What is your
Hardware Setup?
pH
ORP
[RELAY2 RELAY1]
Enter doser pump
rated output for
pH: 50 GPD
ORP: 50 GPD
Continue on next page.
What size is the
body of water?
Volume: 10 K
Units: gal-US
What is the pH
Container Size?
3.5 gal-US
Gauge: 6
How long does
your filter run?
Daily: H:08 M:00
Enter ORP info. Press
MENU. “Is your pool
water balanced?
Is your pool
water balanced?
[No]
Balance water
chemistry before
beginning automatic
control
Finished Setup.
Verify your new
settings in the
pH & ORP menus!
NO
YES
Note: The units used for dose size in
the main menus will automatically be
set to milliliters(ml) if either the pool
volume is set to less than 4k gallons
or the
container size is specified in liters.
Note: 1 oz = approximately 3 ml.
