Pentair Inground Suction Pool Cleaner, Инструкция по установке и эксплуатации

Страница: 9 / 20

3
Kreepy Krauly ® Kruiser ™ Installation and User’s Guide
Hose Assembly
1. Connect hose sections to reach from
vacuum/suction source to the farthest point
of the pool, plus one section.
2. Once the hose is assembled, attach the
female hose end onto the swivel of your
Kreepy Krauly
® Kruiser ™ .
Vacuum Seal Installation
1. Pull the Vacuum Seal over the Cleaner’s
Foot Pad to fi t properly into the Foot Pad’s
groove as shown in the illustration.
2. Be sure the curved tips face upwards.
3. Check with your hand that the Vacuum
Seal rotates freely once it is in the groove.
Attaching Hose Weights
The number of hose weights required is determined by the maximum depth of your
pool - the deeper your pool, the more weight is needed. Use the table below to find
the number of hose weights needed for your pool.
1. Attach hose weights to the hose to keep
the cleaner at a 45° angle in the pool for
maximum coverage.
2. If needed, adjust the 1
st
hose weight (closest
to the cleaner) towards the 2
nd
hose weight.
(The water density in each pool can vary
due to mineral and salt content).
3. Adjust the hose weights until the cleaner
sits evenly on the bottom of the pool at a
45° angle.
Hose must equal longest stretch
— — plus one length
—
Pool Depth Weight Placement
More than 6 feet, but
less than 9 feet 1 weight: one 12 to 20 inches
from the swivel head
More than 9 feet but
less than 12 feet
2 weights: one 12 to 20
inches, one 6 feet from the
swivel head.
More than 12 feet
3 weights:* one 12 to 20
inches, one 6 feet and one
10 feet from the swivel head.
*Contact your Pentair Water Pool and Spa
®
dealer if you
need to purchase additional hose weights.
No weights on
the hose cuffs
Hose Weights Note:
The hose length
illustrated is not representative
of actual size. You will need to
use more sections than shown.