Pentair BIOSHIELD 522635, Инструкция по установке и эксплуатации, Страница: 7 / 16

4
INSTALLATION
Quartz Sleeve Assembly and Installation
Quartz Sleeve Assembly Includes:
Quartz Sleeve
White Quartz Sleeve Retaining Nut
Rubber Gasket
Rubber O-ring
Clear Quartz Sleeve Module
Clear Quartz Sleeve Module O-ring
Power Supply Gasket
Assembly Instructions
1. Position the white quartz sleeve retaining nut, rubber gasket and rubber o-ring over the
open end of the quartz sleeve as shown in Photo A.
2. Slide the “open-end” of the quartz sleeve (with nut/gasket and o-ring in position) into the
clear quartz sleeve module. See Photo A.
3. Thread the white retaining nut onto the clear quartz sleeve module’s male threads and
hand-tighten. See Photo B.
4. While hand-tightening the white retaining nut onto the clear quartz sleeve module, use
your index nger to ensure that the open-end of the quartz sleeve mates smoothly with the
inside lip of the clear quartz sleeve module; this signi es a good t. See Photo C.
5. With the quartz sleeve positioned inside the clear quartz sleeve module properly, nish
hand-tightening the white retaining nut. When the white retaining nut is tight, the quartz
sleeve should appear straight inside the clear quartz sleeve module (see Photo D).
Note: If the quartz sleeve appears crooked it may leak. Disassemble and try again.
6. Carefully slide the quartz sleeve assembly into the UV vessel (see
Photo E). The domed-end of the quartz sleeve should slide into
the coupling located on the non-electrical end of the UV vessel
(see Photo F).
Improper assembly may result in water damage to electrical components and unsafe conditions. The manufacturer is
not responsible for damage cause by improper re-assembly of these parts.
A
B
C
D
E F
BIOSH IELD ® U V D isinfection Sterilizer Installation and U ser’ s Guide