EQUIPMENT INSTALLATION
13
Rev E
Figure 4
700 Series Controller Identification
Location Selection
Location of a water treatment system is important. The following conditions
are required:
•
Level platform or floor
•
Room to access equipment for maintenance and adding regenerant (salt)
to tank.
•
Ambient temperatures over 34
F (1
C) and below 120
F (49
C).
•
Water pressure below 120 psi (8.27 bar) and above 20 psi
(1.4 bar).
•
In Canada the water pressure must be below 100 psi (6.89 bar).
•
Constant electrical supply to operate the controller.
•
Total minimum pipe run to water heater of ten feet (three meters) to
prevent backup of hot water into system.
•
Local drain for discharge as close as possible.
•
Water line connections with shutoff or bypass valves.
•
Must meet any local and state codes for site of installation.
•
Valve is designed for minor plumbing misalignments. Do not support
weight of system on the plumbing.
•
Be sure all soldered pipes are fully cooled before attaching plastic valve
to the plumbing.
Time & Day
Regen Time & Day
Salt
SU MO TU
WE TH FR SA DAYS
LBS
PM
MIN
KG
x100
x2
P
H
C
Capacity
Hardness
LCD Display
Manual Regen Button
Down Button
Set Button Up Button
740/760 Turbine Input or Dry Contact Signal Input
Main Motor &
Optical Sensor
Connection
AC Adapter
(low voltage)
Input
Front
Back
No Salt Detector
Connection
Right Side
Left Side
