Rev. A 1-2-02
P/N 472032
5
Operation (Lighting)
FOR YOUR SAFETY: READ BEFORE LIGHTING
A. This heater is equipped with an ignition device
which automatically lights the main burners.
Do not try to light the burners by hand.
B.
BEFORE OPERATING,
smell all around
the heater area for gas. Be sure to smell next
to the floor because some gas is heavier than
air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
-
Do not try to light any heater.
-
Do not touch any electrical switch; do not use
any phone in your building.
-
Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
-
If you cannot reach your gas supplier, call the
Fire Department.
C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will
not push in or turn by hand, don't try to repair it.
Call a qualified service technician. Forced or
attempted repair may result in a fire or explosion.
D. Do not use this heater if any part has been under
water. Immediately call a qualified service
technician to inspect the heater and to replace
any part of the control system and any gas
control which has been under water.
E. The MiniMax NT Standard incorporates the
Pentair 7800 temperature controller to aid you
in the operation of the heater, and to assist in
diagnosing a failure in the heater’s function.
MINIMAX NT STANDARD HSI ELECTRONIC IGNITION LIGHTING/OPERATION
1
.
STOP!
Read the safety information above.
2.
Set the thermostat to the lowest setting.
3.
Turn off electric power to the heater.
4.
This heater is equipped with an ignition device
which automatically lights main burners. Do
not try to light the burners by hand.
5.
Remove the control access door.
6.
Push in gas control knob slightly and turn clock-
wise
to “OFF”. (If not on “OFF” position.)
7.
Wait five (5) minutes to clear out any gas. If you
then smell gas,
STOP!
Follow "B" in the safety
information above. If you don't smell gas, go to the
next step.
8.
Turn knob on gas control counterclockwise
to “ON”; see Figure 1.
If you do not follow these instructions exactly, a fire or explosion may result causing personal injury, loss of life
and property damage.
Do not attempt to light the heater if you suspect a natural gas leak. Lighting the heater can result in a fire or
explosion which can cause personal injury, death, and property damage.
WARNING
9. Replace the control access door.
10. Turn on the electrical power to the heater.
11. Set the thermostat to the desired setting.
12. If the heater will not operate, follow the instruc-
tions "To Turn Off Gas To Heater" and call your
service technician or gas supplier.
OPERATING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the heater if
service is to be performed.
3. Remove control access door.
4. Push in gas control knob slightly and turn
clockwise to "OFF".
Do not force.
5. Replace control access door.
Gas control knob shown in “ON” position.
Figure 1.
OFF
ON
Gas
Inlet
