Pentair Pool Products LEGEND LL105G, Руководство по установке

Страница: 9 / 20

6
The Sweep Hose operates in a gentle sweeping
motion to prevent debris from becoming trapped
in hard to reach corners of the pools.
If the Legend® does not travel to all areas of the
pool, turn off the booster pump and pool
filtration
pump and make the necessary
adjustments from the instructions in the next
section.
G. Fine Tuning the Legend
®
1. Thrust Jet Adjustment
There is a Thrust Jet located in the back of the
Legend®. This Thrust Jet alters the direction of
the cleaner.
The factory standard position for
the jet is set in the middle and straight out. (See
illustration below).
2. Sweep Hose Adjustment
The Sweep Hose operates in a gentle sweeping
motion. To increase or decrease the motion of
the Sweep Hose, there is an adjustment screw
located on the Feed Mast Barb below the
F. Checking Operation
When operating correctly, the Legend® will
travel in a random pattern throughout the pool,
vacuuming and sweeping the bottom.
The
climbing ability of the Legend® is dependent on
the pools structure and water flow coming into
the pool. It will perform more efficiently in pools
without sharp angles or curves in the transition
from the floor of the pool to the wall.
The Legend® comes with a Twist Lock Pressure
Relief Valve (Wall Fitting).
If the Legend® is
receiving too much water pressure, the Relief
Valve in the Wall Fitting will release the excess
water pressure.
Approximately every three minutes and 30
seconds the Legend® will go into a back-up
mode. The Back-Up Valve cycle time, while in
the back-up mode, is approximately 30 seconds,
pulling the Legend® from problem areas.
New Back-Up Valve Information:
The Back-Up Valve Insert (#MBUVP) which is
slid into the slot over the jet of the valve. This is
secured with a stainless steel screw (#VX-9) as
show in the diagram. The insert will be set from
the factory with the larger (3/8") hole over the
opening of the jet. The larger hole is used for the
Legend cleaner. If you change the insert to the
smaller (1/4") hole, the Back-Up Valve will have
increased jet pressure and possibly tangle your
hose.
® ®
LEGEND ® INSTALLATION MANUAL
MBUVP
Screw
Back-Up Valve
®