Pentair Pool Products IntelliComm Communication Center, Руководство по установке

Страница: 8 / 16

2
IntelliComm Communication Center Installation Guide
Installing the IntelliComm enclosure
Install the IntelliComm enclosure at the equipment pad at a maximum of 50 feet from the pump. Leave sufficient clearance
on all sides of the enclosure. Be sure that the 50 ft. communication cable from the pump can reach the IntelliComm
enclosure location. The IntelliComm enclosure can be mounted on a wall or vertical flat surface up to 50 feet away from
the cell controller.
CAUTION: The IntelliComm communication center must be installed more than 8 ft. (2.44 m) from the pool
edges.
Note: For pump operating instructions, see the pump’s Installation and User’s Guide.
Mounting the IntelliComm enclosure
1. Using a medium flat blade screwdriver, loosen the two plastic screws on the front cover and open the front
cover.
2. Mount the enclosure on a flat surface such as a wall or post. Mark each mounting screw hole location.
3. Drill four ¼ inch (6.35 mm) holes. Install anchors if necessary and one screw for each enclosure hole.
4. Position the enclosure in place over the holes and install the four mounting screws into the enclosure screw
holes. Tighten the four screws to secure the enclosure.
IntelliComm Communication Center
Mounting screw access hole
Enclosure retaining screw
Mounting screw access hole
Enclosure retaining screw