P E N N Y + G I L E S D R I V E S T E C H N O L O G Y
T I L L E R M O D U L E
Solo Technical Manual SK74484/1
Chapter 3:
41
All LED outputs are "low side drivers", this means the LEDs
must be connected between "switched 24V(36V)" (normally CON1
pin 12) and the relevant output pin. The LED current is 10mA:
this is set by resistors on the tiller module, consequently, LEDs
with integral series resistors should not be used. Although CON1
pin 12 is "switched 24V(36V)", it is only a low current supply and
must not be used for any purpose other than the LED anode
connections.
The following connections should be made.
CON 1 Pin
Connect to
Function
1
All switches
Switch supply
2
On/Off switch
On/Off switch input
3
Freewheel switch
Freewheel switch input
4
Slow/Fast switch
Slow/Fast switch input
5
Reverse switch
Reverse switch input
6
Horn switch
Horn switch input
7
Spare
100mA 0V supply
8
On/Off LED cathode
On/Off LED output
9
Reverse LED cathode
Reverse LED output
10
Slow/Fast LED cathode
Slow/Fast LED output
11
Freewheel LED cathode
Freewheel LED output
12
All LED anodes
24V(36V) supply for LEDs
CON 2 Pin
Connect to
Function
1
Solo P2-5
Solo On/Off switch input
2
24V(36V) via 1A fuse
24V(36V)
