6
4
Setup
System Components
The Photoreactor m2 is comprised of the following components:
▪
Base Unit
▪
450nm LED Module*
▪
8ml Reflector
▪
40ml Reflector
▪
gc Vial Holder
▪
4ml Vial Holder
▪
8ml Vial Holder
▪
20ml/40ml Vial Holder
▪
Power Supply
▪
Power Cable
*420nm and 365nm wavelength LED modules are separately available
Choosing a Location
Set the Photoreactor m2 horizontally
on its four neoprene feet
on a flat surface in a place that allows for
adequate air ventilation on the back and bottom. Do not place the Photoreactor m2 on top of paper or
loose material that may be drawn into any ventilation port. Do not position the unit so that the back of
the unit is obstructed. The Photoreactor m2 should only be transported in the horizontal position.
NOTE:
For adequate ventilation, maintain at least 4” of
clearance around all sides of the unit in an unenclosed
space.
Connecting the Power Cord
Insert the power supply receptacle-end into the receptacle on the side of the unit. Insert the power cord
plug into a standard AC outlet.
Warning: To avoid risk of electric shock, this
equipment must only be connected to a supply mains
with a protective earth.
