Arctica 3200xlp switch Installation Guide Chapter 2 Installation Notice
4
All sources of interference, whether from the device/system itself or the outside
environment, will affect operations in various ways, such as capacitive coupling, inductive
coupling, electromagnetic radiation, common impedance (including the grounding
system) and cables/lines (power cables, signal lines, and output lines). The following
should be noted:
■
Precautions should be taken to prevent power source interruptions;
■
Provide the system with a dedicated grounding, rather than sharing the grounding
with the electronic equipment or lightning protection devices;
■
Keep away from high power radio transmitters, radar transmitters, and high
frequency strong circuit devices;
■
Provide electromagnetic shielding if necessary.
2.1.6.Rack Configuration
The dimensions of the Arctica 3200xlp is designed to be mounted on a standard 19’’
rack, please ensure good ventilation for the rack.
■
Every device in the rack will generate heat during operation, therefore vent and fans
must be provided for an enclosed rack, and devices should not be stacked closely.
■
When mounting devices in an open rack, care should be taken to prevent the rack
frame from obstructing the switch ventilation openings. Be sure to check the
positioning of the switch after installation to avoid the aforementioned.
Caution
!
If a standard 19’’ rack is not available, the Arctica 3200xlp can be placed on a clean
level desktop, leave a clearance of 100mm around the switch for ventilation, and do not
place anything on top of the switch.
2.2.Installation Notice
■
Read through the installation instruction carefully before operating on the system.
Make sure the installation materials and tools are prepared. And make sure the
installation site is well prepared.
■
During the installation, users must use the brackets and screws provided in the
accessory kit. Users should use the proper tools to perform the installation. Users
should always wear antistatic uniform and ESD wrist straps. Users should use
standard cables and connecters.
■
After the installation, users should clean the site. Before powering on the switch,
users should ensure the switch is well grounded. Users should maintain the switch
regularly to extend the lifespan of the switch.
■
Statement indicating that a readily accessible disconnect device shall be
incorporated in the building installation wiring.