Rev. 1.0
Penguin Computing
39
Figure 35: Installing the Cage Nuts
Step 7.
Attach the frame to the rack by using ten-spacer cage nut to adapt the square openings in the
vertical support, and then screw ten M6 pan head screws—four in the front part of the rack, and six
in its rear part. The recommended torque is 6.55-7.35 Nm. See the figure below.
Figure 36: Attaching the Frame to the Rack
Do not remove both of the blank covers at the same time. When no
system is installed, at least one of them should be present to support the
frame’s partition.
