Rev. 1.0
Penguin Computing
22
Step 5.
Mount the system into the rack enclosure, and attach the brackets installed on the system to
the rack’s posts. Secure the brackets to the rack posts by inserting four M6 screws in the designated
cage nuts, as described in the figure below. Do not tighten the screws yet.
Figure 12: Attaching the Brackets to the Rack
Step 6.
Slide the two blades into the left and right rails, and then adjust them to fit the depth of your
rack. Use four M6 screws (D) to fix the blades into the rack. Do not tighten the screws yet.
Figure 13: Sliding the Blades in the Rails
Step 7.
Secure the system in the rack by tightening the 8 screws inserted in Step 5 and Step 6 with a
torque of 4.5±0.5 Nm.
