Pendulum GPS-12, Руководство пользователя

Страница: 14 / 62

WARNING: Capacitors inside the in-
strument can hold their charge
even if the instrument has been
separated from all voltage sources.
Assembling the Rackmount
Kit
–
Make sure the power cord is disconnected
from the instrument.
–
Turn the instrument upside down.
See Figure 2-4.
–
Undo the two screws (A) and remove
them from the cover.
–
Remove the rear feet by undoing the two
screws (B).
–
Remove the four decorative plugs (C) that
cover the screw holes on the right and left
side of the front panel.
–
Grip the front panel and gently push at the
rear.
–
Pull the instrument out of the cover.
–
Remove the four feet from the cover.
Use a screwdriver as shown in the following il-
lustration or a pair of pliers to remove the
springs holding each foot, then push out the
feet.
–
Push the instrument back into the cover.
See Figure 2-4.
–
Mount the two rear feet with the screws
(B) to the rear panel.
–
Put the two screws (A) back.
–
Fasten the brackets at the left and right
side with the screws included as illustrated
in Figure 2-6.
–
Fasten the instrument in the rack via
screws in the four rack-mounting holes
The long bracket has an opening so that cables
for Input A, B, and C can be routed inside the
rack.
n
Reversing the Rackmount Kit
The instrument may also be mounted to the
right in the rack. To do so, swap the position of
the two brackets.
2-6 Rackmount Adapter
Preparation for Use
Figure 2-4 Remove the screws and push
the frequency standard out of
the cover.
Figure 2-5 Removing the feet from the
cover.
Figure 2-6 Fitting the rackmount brackets
on the counter.