8
062044 R02
Pivot seat rail up and down to ensure it moves freely with
no side to side play. There should be slight resistance from
nuts as you lift up the chair rail. (Tighten chair rail nuts as
necessary) Shrouds should also be on the outside of the
chair support and not get pinched when lowering the rail.
Re-install seat cushion by engaging plastic hooks on rear
rail brackets. Secure seat cushion by rotating seat handle
back 90 degrees.
InsTallaTIon InsTRUCTIons, ConT’D
Properly connect external facility electrical, air and water to
chair as needed.
Properly route or bundle cords and lines to reduce risk of
injury or tripping. Replace and secure all covers properly.
Plug in chair and listen for an audible beep.
Operate chair through all range of motions and functions to
verify proper operation and complete installation checklist
found at the back of this manual.
sTeP 8:
sTeP 7:
WaRnInG:
To avoid risk of electric shock, this
equipment must be connected
only
to supply
mains with protective earth.
WaRnInG:
Use a licensed electrician for all
wiring.
WaRnInG:
Power cords and their associated
parts can not be substituted without increased
risk of electric shock or fire. We recommend the
use of original equipment replacement parts
only. Power cords must be installed by qualified
personnel. Make sure all service loops, strain
reliefs and cord guards are in place and that
line, neutral and ground wires are secured.
WaRnInG:
The optional
ErgoSoothe must
be supplied with a 1/4 in. OD, 80-100 psi air
supply line with no oil or other contaminants.
The pressure is pre-set and cannot be adjusted.
If the relief valves begin venting, turn off the
control switches and contact a Pelton & Crane
authorized service technician for repair.
WaRnInG:
This product must be disinfected
before use. See Use & Care manual for further
instructions
Содержание SP18
Страница 13: ...13 062044 R02 ...
