Pelton & Crane Solaris, Инструкция по использованию и уходу

Страница: 17 / 19

17
042281 R03
Door Hinge adjustment
The doors are adjusted at the factory so the doors open and
close properly. However, an occasional adjustment may be
required over a period of usage.
Unsnap hinge cover from hinge. Using a green handle screw
driver from grass or a #2 posi-drive driver only , adjust doors
as follows:
Screw 1 will move the door SIDE to SIDE. Clockwise pulls
the hinge in, lowering the far corner of the door. Counter-
clockwise pushes the door outward, raising the far corner of
the door.
Screw 2 allows the door to be moved UP & DOWN.
Screw 3 will move the door TOWARD and AWAY from the
module.
Drawer Adjustment
The drawers are adjusted at the factory. However, an
occasional adjustment may be required over a period of
usage. These adjusting screws are located in each front
corner of the drawer.
Using a #2 posi-drive driver only , adjust doors as follows:
1. Vertical adjustment : Lightly loosen screws ( 2 )
counterclockwise, adjust screw ( 1 ) up or down, tighten
screws ( 2 ).
2. Horizontal Adjustment : Lightly loosen screws ( 2 ),
adjust front to desired position, tighten screws ( 2 ).
3. angle Correction : Loosen top screw or bottom screw ( 2 )
according to your needs. Push angle correction wedge
(type 6155) in between, tighten screws ( 2 ) and tear off
wedge. Angle correction ±1.
1.
2.
3.
1.
2.
aDJUsTMenTs