RESET INSTRUCTIONS
This heater is equipped with an internal High Limit Switch which causes the unit to
stop operating in the event the internal temperature exceeds normal operating
temperatures.
IF THE UNIT SHUTS DOWN
1) TURN THE UNIT OFF
2) UNPLUG UNIT AND WAIT 10 MINUTES
3) PLUG IN AND TURN ON
TROUBLESHOOTING
CLEANING AND STORAGE
We recommend that the heater be cleaned at least once a month and before off-season
storage.
Turn the heater off and unplug it. Allow it to cool down.
Use a dry cloth to clean the external surfaces of the heater.
DO NOT USE WATER, WAX, POLISH OR ANY CHEMICAL SOLUTION.
Clean your heater using the above-mentioned steps, then pack the heater in its
original container and store it in a cool dry place.
This heater does not disassemble.
The motor is factory lubricated for life, and will require no further lubrication.
SPECIFICATIONS
4
If your heater fails to operate, please follow these instructions:
Ensure that your circuit breaker or fuse is working properly.
Be sure the heater is plugged in and that the electrical outlet is working properly.
Check for any obstruction. If you find any obstruction, turn the heater off. Unplug
the heater and wait a few minutes for it to cool down. Carefully remove the
obstruction. Plug the heater in and turn it on again by referring to the
OPERATING INSTRUCTIONS
.
NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR HEATER,
PLEASE SEE THE WARRANTY INFORMATION FOR INSTRUCTIONS.
PLEASE DO NOT ATTEMPT TO OPEN OR REPAIR THE HEATER
YOURSELF. DOING SO MAY VOID THE WARRANTY AND COULD
CAUSE DAMAGE OR PERSONAL INJURY. IF THE PROBLEM STILL
PERSISTS, PLEASE CONTACT US BY REFERRING TO THE SERVICE &
SUPPORT INFORMATION ON THE FOLLOWING PAGE.
Model No.: HF-0060
Voltage: 120V, 60Hz
Current: Maximum 10 Amps
Power: Maximum 1200 Watts
Tolerances on all specifications: Not exceeded than 105%
PRINTED IN CHINA
