pellenc EXCELION 2 LH, Руководство пользователя и инструкции по эксплуатации

Страница: 72 / 84

BRUSH CUTTER EXCELION 2 LH
53_154421-A
8.3. STORING THE TOOL
Important
• In the event of prolonged storage, grease the output shaft of the angle gear (refer to Section 6.5, “Angle
gear lubrication”).
• Always make sure the tool is clean and its battery is charged before storing it.
• The Brush cutter Excelion 2 LH must be stored away from heat, dust and humidity at an ambient temperature
between 0° C and 40° C.
• The machine and the battery must be stored in their original packaging, in a dry place and out of the reach
of children.
The Brush cutter Excelion 2 LH is equipped with an at-
tachment point (17) which allows the tool to be suspend-
ed against a wall.
In the case of a first installation:
Install at a height of 1.90 metres from the ground:
1. • either a screw whose head is at least 5 mm high
and has a head diameter of less than 10 mm.
• Or a hook whose diameter is less than 5 mm.
Note
The attachment point should protrude 25mm
from the wall.
Use screws suitable for the material that com-
poses your wall.
2. Hang the Brush cutter on the wall by its attachment
point (17).
72