Page 2 of 3
D. Grasp the panel from the exterior and lift the bottom
off the track and away from the sill. If the panel
cannot be lifted high enough for the rollers to clear
the track, adjust the rollers to lower the panel for
more clearance.
E. Set panel aside.
1D
2A
2B
1D
2A
1
Removing The Vent Panel (Continued):
2
Convert strikes:
Designer 5/2016 - 8/2018 and ProLine model 4 5/2016 - 8/2018, Sliding Patio Doors; the strikes on the frame/joining
panel must be converted to condensed 2pt lock by removing and adding strike locations to match the replacement
panel with the included drill template/jig.
A. Remove strikes from current frame/joining panel.
B. Align the drill template/jig and attach it to the edge of the panel
by inserting the provided screws through the bottom two holes
of the template/jig. The screws are aligned with the existing strike
holes at the bottom of panel edge on Designer Series and aligned
the lower set of holes with existing jamb holes on Proline Model
4. Remove the two screws on the edge near the bottom of the
ProLine door panel and attach the drill template/jig using those
screw holes.
