Part Number: 807X0101
© 2012 Pella Corporation
CASEMENT WINDOW LOCK LEVER REMOVAL AND INSERTION
Note: You may want to remove the lock lever prior to finishing the window,
or if it needs to be replaced with a lock lever in a different finish.
A.
Unlock and open the window.
B.
Place the lock lever in the locked position.
C.
From the exterior of the window,
insert a small flat-blade screwdriver
between the cam and lock lever near the bottom of the opening
between the stop and frame gasket.
D.
Push the screwdriver inwards
with a small amount of pressure; then turn
the blade slightly clockwise for a left hand unit, counter-clockwise for a
right hand unit.
DO NOT
over-twist the screwdriver, this can damage the
lock driver.
Note: This will release the hook in the lever from the cam hook.
E.
Remove the lock lever
by pulling it toward the interior of the building.
F.
To install a lock lever,
hold it in the lock position and insert it, from the
interior, into the slot until it snaps into the cam.
Interior
B
Exterior
C
Interior
F
Exterior
D
E
INSTALLING ROTO COVER AND CRANK
Note: Finish the interior of the window and allow the window to dry before proceeding with these instructions. (To open
the window for finishing, partially insert the lock handle into the jamb, unlock the unit, temporarily attach the crank handle
and turn to open.)
A.
Place the cover over the operator stud and snap into
place.
Position the pocket end of the cover into place.
Note: If the cover does not have the screw hole, apply
pressure on the pocket end of the cover to snap the cover
into place and proceed to step C.
B.
Insert the provided screw into the hole in the bottom
of the pocket.
8VHD3KLOOLSVVFUHZGULYHUWRVHFXUH
the pocket screw snug against the bottom of the
pocket to avoid scratching the crank handle knob. DO
NOT over tighten.
C.
Use a medium size flat-blade screwdriver to loosen
the set screw in the crank handle.
D.
Slide the crank handle onto the stud.
Unlock, open
window, then close and lock window.
E.
Fold the crank handle down
and check alignment of
knob with the pocket.
Note: You may need to adjust the crank position on the
stud until the correct alignment is achieved.
F.
Open the crank and tighten the set screw.
*
After the final installation, fold the crank over and snap the knob into the pocket.
Note: Even with the window open the crank can be folded to avoid interferring with the window treatments.
Pocket End
Operator Stud
Screw Hole
A
B
Crank Handle
Operator Stud
Set Screw
C
D
Knob
E
