Pelican PRO-RO6, Руководство по установке, Страница: 14 / 26

.13
PELICAN PRO-RO 6 Instruction Manual
Installation Checklist
Maintenance
1. System is located where it will not be subject to physical impacts or rough contact by heavy objects.
2. Feed water pressure to the unit is no less than 40 psi and no greater than 80 PSI.
3. Ensure the plastic retainer clip that holds the desalinator cartridge in place is fully engaged and locked in place. The
slide locks must snap into place in the slots. If the clip does not snap easily into place through the slots it means the
cartridge is not fully inserted into the connectors. Press top or bottom of cartridge to engage connectors until it snaps
into place properly.
4. All tubing connections, especially push-in quick connections, are fully inserted.
5. Tubing connected between the faucet and the drain saddle fitting (the fitting attached to the sink drain pipe) runs "down-
hill
〃
to the drain. There should be no loops or places where water would not flow out to the drain.
6. Feed water valve is open.
7. Within one to two hours after initial application of water pressure, check again for leaks especially at the tank, faucet tub-
ing and connectors. These parts will not see full pressure until approximately 2 hours after the system is activated.
8. Flush three tankfuls of product water to drain. If a chlorine scent persists, repeat flushing procedure.
1. Close the small shut-off valve on the feed valve assembly.
2. Close the tank shut-off valve.
3. Open the dispensing faucet to relieve system pressure. Close dispensing faucet when flow has stopped.
4. Remove the cover from the front of the system. Remove the retaining clip. Pull the cartridge off the system evenly at
top and bottom. Dispose of used cartridge.
5. Install the new cartridge, rocking gently from side to side as necessary until the cartridge tubes are properly engaged in
the unit connectors. Install the retaining clip, ensuring the slide locks snap into place in the slots. If the clip does not
snap easily into place through the slots it means the cartridge is not fully inserted into the connectors. Press the top or
bottom of the cartridge to engage the connector so that it snaps fully into place. Failure to properly install the retaining
clip will result in accidental leaks and flooding.
6. Open the small shut-off valve on the feed valve assembly. Open the dispensing faucet.
7. Close dispensing faucet after water starts running.
8. Observe system for any leaks, especially at newly re placed cartridge.
9. Open the tank shut-off valve.
10. The system should be flushed at least once as described above under Section 8.
Cartridge Replacement