EN 17
Starting a cycle wash
1. Draw out the lower and upper basket, load the dishes and push them back.
It is commended to load the lower basket first, then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket. The power supply refer to the page ”Technical data sheet”.
Make sure that the water supply is turned on to full pressure.
4. Open the door and press the on/off button to switch on the appliance.
5. Choose a program, the response light will turn on. Then close the door, the dishwasher will
start its cycle.
Changing the program mid-cycle
A wash cycle can only be changed if it has been running for a short time. Otherwise the
detergent may have already been released and the dishwasher may have already drained the
wash water. If this is the case, the dishwasher needs to be reset and the detergent dispenser
must be refilled. To reset the dishwasher, follow the instructions below:
1. Open the door a little to stop the dishwasher. When the spray arm stops working, you can
open the door completely.
2. Press the program button for more than three seconds to set the appliance into
standby state.
3. You can change the program to the desired cycle setting.
4. Then close the door, the dishwasher will start its cycle.
3 sec
PROGRAMMING THE DISHWASHER
Содержание GVW420L
Страница 1: ...Instructions for use Dishwasher Anleitung Geschirrspüler GVW420L ...
Страница 67: ...DE 31 ...
Страница 68: ...811588 VER 1 26 09 2019 811588 811588 ...