Pelgrim 493237, Руководство пользователя

Страница: 15 / 36

EN 15
Symptom Possible cause Solution
The pans make a noise while
cooking. This is caused by the energy
flowing from the hob to the
saucepan. This is caused by the energy
flowing from the hob to the
saucepan. This is not harmful
for the pans or hob.
You have switched a cooking
zone on but the display keeps
flashing. A pan detection
symbol (U) will appear in the
display. The pan you are using is not
suitable for induction cooking
or has a diameter of less than
12 cm. Use a good pan.
A cooking zone suddenly
stops working and you hear
a signal. The preset time has ended. Switch off the signal by
pushing a random button.
The hob is not working and
nothing appears in the display. There is no power supply due
to a defective cable or a faulty
connection. Check the fuses or the
electric switch (if there is no
plug).
A fuse blows as soon as the
hob is switched on. The appliance is incorrectly
connected. Check the electrical
connections.
Error code ER03. The control panel is dirty or
has water on it. Clean the control panel.
Error code E3. Unsuitable pan used. Use a pan suitable for
induction cooking.
Error code E2. Appliance over heated. The appliance has been
switched off because of over
heating.
Fault code E6. The appliance has been
connected incorrectly and/or
the mains voltage is too high. Have your connection
changed.
The fuse in the appliance will
blow if all 4 cooking zones are
used on a high power level. Appliance is not adjusted to
"Lo" by software. Set the appliance to "Lo"
(power limiter). See ‘Set the
appliance to ‘Lo’.
Zone(s) don't work or don't
heat up sufficiently. Appliance is connected to a 1
phase/16 Amp and adjusted
to "Lo". The appliance's inbuilt power
limiter limits the maximum
power that can be used
simultaneously.
Other fault codes. Defective generator. Contact the service
department.
ERRORS