PELA 74367, Быстрый старт

Страница: 5 / 8

5
Contact
PELA Tools
Solängsvägen 13
SE-513 70 Borås
Phone: 033-202650
E-mail: order@pelatools.com
Environmental protection /
Scrapping
Recycle any unwanted material,
do not throw it in the household
rubbish. All machines, accessories
and packaging must be sorted and left
at a recycling center and disposed
of in an environmentally friendly
manner.
Description
Extra powerful motor stand that can withstand
680 kg. Specially designed for heavier and larger
engines. Equipped with four cast iron wheels. The
distance between the center of the mounting plate
down to the top of the legs is 630 mm. Width: 800
mm
Warning
• Never exceed the maximum capacity of 680 Kg.
•
Always place the motor stand on a hard sur-
face.
• Never move the motor stand over a floor with
cracks or other defects when you have a mo-
tor on the stand. This entails risks of personal
injury and / or damage to the motor stand as
well as a suspended motor.
•
Never work directly under the motor attached to
the stand.
• Always make sure and check that the motor
stand is stable and secure.
• Inspect the engine rack at regular intervals and
look for damage, defects or loose parts.
•
By following the instructions above, you minimi-
ze the risk of personal injury and / or property
damage.
Assembly instructions
1. Attach the two (2) front 3.5 "wheels (# 15) to
the legs (# 14) using the bolts (# 18), nuts (#
17), and lock washers (# 16).
2. Attach the two (2) rear 3 "wheels (# 13) to the
rear beam (# 9) with nuts (# 12) and lock wash-
ers (# 11).
3. Attach the two (2) legs (# 14) to the rear beam
with the bolts # (10).
4. Insert the column (# 8) in the rear beam (# 9)
and secure with a bolt (# 10).
5. Insert the rotating plate (# 6) through the top of
the column (# 8). Rotate the plate until the hole
in the top of the column (# 8) meets the hole in
the arm of the rotating plate (# 6). Then insert
the locking pin (# 7).
6. Insert the handle (# 1) into the hole on the rota-
ting plate arm (# 6).
7. Secure the four (4) engine mounts (# 2) to the
rotating plate (# 6) with bolts (# 5), flat washers
(# 3), and nuts (# 4).
8. Important, make sure everything is securely
fastened before use.