PELA 532900, Руководство пользователя, Страница: 6 / 8

6. Hang the hose reel on the screws.
7. Tighten the screws.
8. Connect with inlet hose end with the air
compressor.
Mount to hollow wall and masonry wall
Recommended tools
• masking tape
• bubble level
• electric drill
• Ø10mm(Ø3/8in)drill bit
• hammer or mallet
• Philips head serew driver
Steps
1. Tape the drilling template on the wall at a
convenient height, making sure the holes are
between studs.
2. Check the hole centers with the level to ensure
they are plumb.
3. Drill (3) three holes with a Ø10mm(Ø3/8in)
masonry drill bit on the template centers.
4. Tap plastic anchors (B.2) into holes with a
hammer or mallet.
5. Drive mounting screws (B.1) into the plastic
anchors, leaving about 5mm (1/4in) between the
wall and screw head.
6. Hang the hose reel on the screws.
7. Tighten the screws.
8. Connect with inlet hose end with the air
compressor.
Note! Release pressure when not in use.
Caution: Do not release the hose allowing the
rewind on its own.
Using the hose reel
1. Pull the hose out to the desired length. The hose
will automatically lock in position.
2. Pressurize hose reel and use your air-powered
tool.
When finished using the hose reel
1. Turn off sir supply to hose reel.
2. Release the pressure in the hose reel, by briefly
activating your air-powered tool.
3. Give the hose a short pull to release the ratchet
mechanism.
4. Walk the hose back to the hose reel.
5. If the hose becomes tangled and will not retract
- slowly pull out the hose past the tangled
section and then allow the hose to slowly
retract while guiding the hose back into the
hose reel. Always ensure the hose is clean and
not twisted.
Maintenance
While your product has been made with high
quality materials, degradation can occur over time.
Inspect the hose and housing periodically. If
cracking or blisters are visible, repair before using
again.
Do not dissemble housing.
1. Always keep the hose clean.
2. If the hose becomes dirty, clean it with a damp
cloth while retracting.
3. DO NOT twist the hose while in use.
4. Mount the hose reel in a sheltered area to assist
and protect the performance of the hose and the
reel.
5. DO NOT allow the hose to touch any corrosive
chemicals or fluids.
6. Always retract the hose when not in use.