Peg-Perego PRIMO VIAGGIO I-Size, Инструкция по эксплуатации

Страница: 23 / 28

23
• Position A: the in-vehicle position;
• Position B: the position for transport by hand and for
installation on a base, stroller or chassis;
• Position C: allows the car seat to rock;
• Position D: stops the car seat from rocking.
Instructions for use without base
5 IMPORTANT! The car seat must be parallel to the
ground. If necessary, use rolled-up towels or swimming
pool float tubes under the car seat, in the folds of the
vehicle’s seats.
Fit the car seat with the child seated inside,
remembering to secure the child with the harness. Fully
lower the handlebar of the car seat (point 4 -position A).
6 Slide the lower part of the vehicle seatbelt into the two
guides on the car seat handlebar (fig_a) and buckle it
(fig_b), ensuring the seatbelt is taut, as shown in the
figure.
Grasp the upper part of the vehicle seatbelt and pass it
behind the car seat backrest(fig_c).
7 Insert the belt into the rear guide (fig_a). Tighten the
vehicle seat belt(fig_b). Installation is now complete.
8 To release the harness, press the red button on the
crotch strap buckle (fig. a) and remove the straps.
To engage the harness, place the two shoulder strap
tongues in position and insert them into the buckle of
the crotch strap until they click into place (fig. b).
9 To slacken the harness, insert a finger through the seat
opening (1), keep the metal button pressed, and with the
other hand pull on the straps (2).
10 To tighten the straps until they are snug to the child’s body,
pull the central adjustment strap towards you.
CAUTION: Do not over-tighten the straps, and
ensure you leave minimum slack.
11 IMPORTANT! In winter, do not strap the child into
the car seat wearing bulky, heavy clothing, and do
not place blankets between the child’s body and the
harness. This could cause incorrect positioning of the
safety harness, with serious consequences in the event
of a collision.
Use a blanket or an approved Peg-Perego accessory to
protect your child from the weather.
12 The harness and the “Side Impact Protection” headrest
can be adjusted simultaneously to 5 different heights
so as to follow the growth of the child. To adjust height,
open the door to access the opening in the back of
the seat, press the button on the back of the height
adjuster (arrow 1) while raising or lowering the seat
to the desired position, making sure it is positioned
correctly and clicked in place (arrow 2). Slacken the
straps before adjusting the height of the harness and
headrest.
13 The headrest may be set in 6 different positions.
14 The safety harness is at the correct height when the slits
in the backrest for the straps are located just above the
child’s shoulder level (green area), as shown in the figure.
Make sure the straps are not in the red area.
15 This car seat features the Three Stage Cushion, a system
composed of 3 separate cushions for even the smallest
babies.
A: headrest reducer;
B: backrest reducer cushion;
C: reducer cushion for small seat. Do not use the Three
Stage Cushion with children weighing more than 9 kg.