ISSUED: 10-06-09 SHEET #: 095-9301-2 09-25-10
2 of 6
Wood Stud Installation
1
Use a stud fi nder to locate the edges of the studs.
Use of an edge-to-edge stud fi nder is highly
recommended. Draw a vertical line down the center
of each stud. Place wall plate (
A
) on wall as a
template. Level plate, and mark the center of the
four mounting holes. Make sure that the mounting
holes are on the stud centerlines.
Drill four 5/32"
(4 mm) dia. holes 2 1/2" (64 mm) deep. Attach wall
plate (
A
) using four wood screws (
B
).
• Installer must verify that the supporting surface will
safely support the combined load of the equipment
and all attached hardware and components.
• Tighten wood screws so that wall plate is fi rmly at-
tached, but do not overtighten. Overtightening can
damage the screws, greatly reducing their holding
power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into
the center of the stud. The use of an "edge to edge"
stud fi nder is highly recommended.
WARNING
Mounting Arm Assembly to Wall Plate
Attach arm assembly (sold separately) to wall plate
(
A
) using screws (
C
) as shown.
2
A
B
A
ARM
ASSEMBLY
C
top fl ange
faces up
20"
24"
16"
WSP701
WSP701
WSP700
© 2009, Peerless Industries, Inc. All rights reserved.
All other brand and product names are trademarks or regis-
tered trademarks of their respective owners.
Peerless Industries, Inc.
3215 W. North Ave.
Melrose Park, IL 60160
www.peerlessmounts.com
PA740, PA746F
PA730, PP730, PP740, PA735F
SA730, SP730, SA740, SP740, SA735P, SP735P, SA746P, SP746P
