A . Position valve body correctly in wall (see Fig. 5). UP marking is
on up side and DOWN marking on down side.
B . Connect water supply through coupling nut to valve assemblies.
Pressure testing
A . Install a 1/2" iron pipe plug (not included) on both shower and
tub outlets. Turn connect2(13#) to full " ON " and check all
connections for leaks.
B. Turn connect2(13#) to " OFF " .
A . Caution: Slowly remove pipe plugs from shower and tub outlets.
6
B . After wall treatment. Slide flanges (16#) onto valves and back
against finished wall .
C . Install the handle assembly(17#) (see Fig. 6 ).
A . For tub and shower combined installation,connect bottom outlet
to spout,connect top outlet to shower arm with proper fittings.
(see Fig. 7).
7
Fig .6
Fig .4
CAUTION: Allow at least 2" between tub outlet and tub rim.
The dimension for valve centerline to finished wall is 1-7/8" MIN
to 2-7/8" MAX.Recommended 2-3/8"
Recommended component locations: (see Fig. 3)
3
8"
1-3/8" ~ 2"
C . Turn on hot and cold water supply lines.
D . Rotate connect2(13#) to allow water to flow from tub spout until
there is no foreign matter in discharge.
Note: H - hot water supply C - cold water supply
Up - shower outlet Down - tub outlet
1A. Shower and / or spout outlet hole: 1-1/4" diameter.
1B. Cut or leave a 1-3/8" to 2" diameter hole(Recommended 1-3/4")
for the cold water inlet side(the right side) and for the hot water
inlet side (the left side).
The center to center distance between the cold water inlet and
hot is 8". (see Fig. 4)
1
2
Fig .1
For tub installation only, plug top outlet. For shower installation
only,plug bottom outlet.(see Fig. 2)
Shut off main water supply. Install rigid casting to 1/2" water lines.
Tailpieces on casting are threaded for 1/2" threaded pipe and will
accept 1/2" sweat copper.
1-3/8" ~ 2"
Fig .7
TWO HANDLE TUB & SHOWER FAUCET
INSTRUCTION
Adjustable wrench
Groove joint plier
Pipe wrench
Pipe tape
Phillips screwdriver
Preparation / Assembly
Supply lines
Basin wrench
Hacksaw
Pipe wrench
Tube cutter
Utility knife
Helpful:
Tools:
Require:
12# washer
15# adaptor
16# coupling nut
14# o-ring
13# diverter
11# screw
05# shank
08# bonnet
10# disc
09# stem
06# nut
07# washer
01# index H
02# screw
03# handle
04# flange
19# shower arm
21# spout
20# shower
17# index C
18# shower flange
4
5
Fig .3
CAUTION: Do not turn water off and on repeatedly during initial
period.
Fig .2
1
2
3
4
5
11
10
17
21
9
7
6
8
13
16
15
14
18
19
20
12
4
8
"
8
"
3
0
"
1A
1B
1A
Fig .5
H
DOWN
(Spout)
C
UP
(Shower)
22# washer
22
