2 of 2
ISSUED: 06-03-11 SHEET #:120-9110-1
Hand tighten slope nut (
D
) through 1/4-20 x 1-3/4" carriage bolt (
A
) until snug against bottom of desktop surface.
Thread another slope nut (
D
) upside-down, about two turns from first slope nut (
D
). Insert an open box wrench
between both slope nuts (
D
) and tighten.
NOTE:
Avoid jamming both slope nuts
(
D
) together, doing so may make
it difficult to remove slope nut used for tightening first slope nut (
D
) as shown in figure 3.1. After slope nut is secure
remove bottom slope nut as shown in figure 3.2. Repeat with remaining 1/4-20 x 1 3/4" carriage bolt (
A
).
Fasten two plastic caps (
G
).
TIGHTENING
SLOPE NUT
BOTTOM OF DESKTOP
FIGURE 3.1
FIGURE 3.2
A
3
NOTE
: Do not overtighten slope nut (
D
)
plate may distort
FRONT
D
A
D
Thread two M4 x 16 phillips pan trilobe screws (
B
) to bottom display attachment holes as shown in fig. 4.1.
Remove the two M4 x 16 phillips pan trilobe screws (
B
) and attach display screen to display base using two M4 x
16 mm socket pin screws (
I
) or M4 x 12 mm socket pin screws (
E
) with #8 flat washers (
F
), as shown in figure 4.2.
Tighten with 4 mm security allen wrench (
H
). Use TV supplied screws for remaining holes
.
4
fig 4.1
fig 4.2
B
DISPLAY SCREEN
DISPLAY SCREEN
DISPLAY BASE
NOTE:
Display and base may appear
different than illustrated
NOTE:
Screws are installed using bottom
two display mounting locations.
Installation of Security Screws for Base/Screen Assembly
G
C or E
F
• If screws don’t get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to screen or product may fail.
WARNING
© 2011, Peerless Industries, Inc. All rights reserved.
All other brand and product names are trademarks or registered trademarks of their respective owners.