ISSUED: 11-24-99 SHEET #: 200-9192-2 07-23-04
Visit the Peerless Web Site at www.peerlessindustries.com
For customer service call 1-800-729-0307 or 708-865-8870.
2 of 6
O
A
F
E
D
H
A
C
B
Attach column bushing (
O
) to support column (
A
) using two
screws (
T
). The screws control swivel action, so do not
tighten until product is fully assembled and flat panel is in
viewing position.
Insert rubber grommet (
G
) into hole in bottom of support
column (
A
).
At all three support legs attach support column (
A
) to base
plate (
B
) using fastener plates (
C
), M10-1.5 x 20 mm
socket head screws (
D
), lock washers (
E
), and flat
washers (
F
).
Note:
Leave screws slightly loose until all are
attached, then tighten all screws securely.
Attach base plate (
B
) to concrete floor. Use six Rawl-Bolt
concrete expansion anchors (
H
). Drill 3/8" dia. holes to a
minimum depth of 2".
G
T
• Flat panel weight is restricted to a maximum of 150 lb
(68 kg). Interfacing flat panel into electrical system at
installation site must conform to local electrical codes
governing such installations and be done by a qualified
electrician / electrical contractor.
• Installer must verify that mounting surface will safely
support the combined weight of all attached equipment
and hardware.
WARNING
• For attachment to concrete floor only! All six concrete
expansion anchors must be used.
• Tighten to 420 IN • LB (47.6 N.M.) torque.
WARNING