ISSUED: 07-01-02 SHEET #: 200-9383-2 11-10-04
Visit the Peerless Web Site at www.peerlessindustries.com
For customer service call 1-800-729-0307 or 708-865-8870.
2 of 3
Approx. 1/2"
C
Plasma
C
Use a stud finder and follow the directions that come with it to locate the center point of the stud. Never mount into drywall
alone!
Slide wall bracket (
C
) along stud behind plasma mount leaving about half an inch between center of bottom hole of wall
bracket (
C
) and top of plasma. Using the wall bracket (
C
) as a guide, mark and drill the four 5/32" (4 mm) dia. mounting
holes in the center of the stud, 2 1/2" deep. At this point, it is essential to use a level to level your wall bracket (
C
). If it is
only a few degrees off level, your shelf (A) will not sit straight.
Insert the four wood screws (
D
).
D
• Tighten wood screws (
D
) so that wall bracket (
C
) is
firmly attached, but do not overtighten. Overtightening
can damage screws, greatly reducing their holding
power.
• Never tighten in excess of 80 in • lb (9 N.M.).
• Make sure that mounting screws are anchored into the
center of the studs. The use of an "edge to edge" stud
finder is highly recommended.
WARNING
