IMPORTANT SAFETY PRECAUTIONS
Control assembly and the tools and lifting equipment
used in installation are heavy and may easily cause
personal injury if dropped or carelessly handled. The
normal precautions and safety rules associated with the
installation or repair of machinery, in regard to manual
lifting, use of power equipment, and handling of tools,
must be observed in the installation of this controller.
Petroleum-base cleaning solvents are flammable.
Smoking by personnel, open flame, or other activity
which could ignite vapors in the vicinity of these solvents
is extremely hazardous and must not be permitted.
Do not work under a suspended object unless there is a
positive support under it to stop is fall in event of sling or
hoist failure.
UPON RECEIPT OF CONTROL EQUIPMENT:
Check
carefully to see that all of the equipment has been
received. Report immediately any shortages or damages
to the transportation company handling the shipment,
noting the extent of the damage or shortage on the
freight bill and bill of lading.
Do not leave the unit exposed to weather or construction
hazards. The controller may become mechanically
damaged. This controller is a well designed and carefully
WARNING
Do not work under a suspended object
unless there is a positive support under it to stop its fall
in event of sling or hoist failure. Disregard of this warning
could result in grave personal injury.
ELECTRODE HOUSING:
If furnished in two or more
sections, screw the 1-1/2” pipe (Electrode Housing)
together with couplings provided. Screw the bulb
assembly (20) (21) (22) (23) to the bottom of the 1-1/2”
electrode Housing. Be sure to use a good pipe thread
compound to insure a watertight connection.
To protect and facilitate installation, roll the flexible bulb
into a compact bundle about its vertical axis and
4848247
2
Before attempting examination, handling or repair, be
certain that the electrical power supply is shut off. An
electrical shock from contact with live wires or cards can
be fatal.
Before opening the conduit box of an electric motor, a
switch cover, starter or panel door, be certain that the
power supply is shut off. An electrical shock from contact
with live leads can be fatal.
Before attempting repairs to installation, disconnect
power supply. Controls are automatic. This prevents
accidental running of pump motor. Starting motor during
repair activities could damage pump and may cause
personal injury.
INTRODUCTION
Manufactured unit. It should be given the same attention
accorded to any precision machine.
The satisfactory operation of this controller depends to a
large extent upon proper installation. These in-structions
cannot answer every question that may arise as each
installation will be different. The installer and the
operator of this equipment must use good judgment to
adapt these procedures to the installation.
INSTALLATION
temporarily encircle the roll with tape to secure.
Carefully lower the Electrode Housing assembly, bulb
first, through the opening in the cover over the basin until
the mounting flange rests on the basin cover. Remove
tape.
MOUNTING FLANGE:
The Sealtrode Series P Pump
Controller is furnished with one of two styles of mounting
flanges: standard for mounting on metal basin covers,
and style F for concrete mounting, both illustrated on
page 5.
The Mounting Flange (15) has been preset at the factory
for the correct basin depth and should require no further
adjustment. Refer to page 5 for factory settings.
Содержание Sealtrode P Series
Страница 5: ...DT 4848247 5 ...
