peerless-AV XHB554, Руководство по установке

Страница: 19 / 24

19
2022-07-06 #:180-9147-1
Replacing Cord Cover
1. Run power and signal cords through separate cable channels to prevent unwanted interference.
Route the power cord through the right most cable channel. (see image 1 below).
2. Replace the cord cover ensuring the cords are running through the cable channels and not
getting pinched. Loosely install six M5 hex cap screws, then tighten using 3mm allen wrench
until the cover gasket is fully compressed to the cord gasket.
3. Replace the rear cover plate ensuring the cords are running through the cable channels and not
getting pinched. Fasten the two hex screws on the rear cover plate using
3mm allen wrench to secure. Ensure the rear cover plate is fully compressed
to the back of the display.
• Ensure cord bend radius does not exceed limits set by the
manufacturer.
• Ensure cords are seated properly in the cable channels to avoid
potential damage to cords when rear cover plate is installed.
• Do not remove lanyard that connects the rear cover plate to the display.
• Ensure cables exiting input compartment are routed downward when
installing display in portrait orientation. If the installation requires the
cabling to be routed upward, ensure that the cables are routed with a
drip loop.
CAUTION
Do not overtighten
screws.
3
1 2
M5 hex cap screw
CAUTION
Failure to follow these instructions can result
in the product being damaged or destroyed,
voiding the warranty.
power cord cable channels
Optional: cable management
F
E