10
2020-01-13 #:180-9138-1
Replacing Cord Cover
1. Run power and signal cords through notches. To prevent unwanted interference, route the power
cord through the right most notch (see image 1 below).
2. Place the cord cover over the cords being careful not to pinch any of the cords. Loosely install
(6) M5 hex cap screws then tighten screws on the cord cover using 3mm allen wrench (C) until
the gasket on the cover is fully compressed to the cord gasket .
3. Replace the rear cover plate ensuring that the cords are running through the notches on the
display and not getting pinched. Fasten the (2) thumb screws on the rear cover plate to secure
it in place using 3mm allen wrench (C). Ensure that rear cover plate is fully compressed to the
back of the display.
• Ensure cord bend radius does not exceed limits set by the
manufacturer.
• Ensure cords are seated properly in the cable channels to avoid
potential damage to cords when rear cover plate is installed.
• Do not remove lanyard that connects the rear cover plate to the display.
• If the installation requires the cabling to be routed upward, ensure that
the cables are routed with a drip loop.
CAUTION
Do not overtighten screws
4
3
power cord
1
2
notch
M5 hex cap screw
CAUTION
Failure to follow these instructions can result
in the product being damaged or destroyed,
voiding the warranty.
